◉
HARDWARE MODULE / HEADPHONEINTERACTIVE 3DDRAG · TILT · EXPLORE
PCHardwareTest guide
Headphone Test Online
Put your headphones on and step through left, right, stereo, center and tone playback to confirm each ear receives the right channel. The test generates the audio itself, so there is nothing to download, and the verdict depends entirely on what you hear.
Start Headphone Test Online
Headphone left and right channel test
Run the left test first: only your left ear should hear it. If you hear it on the right, first make sure you are wearing the headphones the right way round, since many models have a marking inside the earcup. Then check the balance and mono audio options in your operating system.
Telling a faulty earcup from a faulty source
If one side sounds weaker, reverse the headphones on your head and repeat the test. If the weak sound follows the earcup, the headphones are the cause, from dirt in the mesh to a damaged driver. If it stays in the same ear, the problem is the cable, the jack or the audio source, or a natural difference between your ears.
Wired, USB and Bluetooth
For wired headphones, push the plug fully into the jack, because a half-seated plug often silences one channel. USB-C adapters add another connection to check. For Bluetooth, confirm the headphones are the selected output, otherwise the tone plays through your speakers instead.
A headphone channel and fit check
Use a moderate listening level. Keep the headphones in their normal left/right orientation and compare the test with a second known stereo source.
| What you observe | Next check | How to interpret it |
|---|
| One earcup is quieter | Reseat the plug, inspect detachable cables and compare another output source. | If the imbalance follows the headphones across devices, the cable, connector or driver may be responsible. |
| Left and right are reversed | Check the L/R markings and wear the headset in its intended orientation. | If the channel test remains reversed on multiple devices, inspect cable wiring or software channel mapping. |
| Bluetooth audio cuts out | Charge the headset, reduce distance and temporarily disconnect other paired audio devices. | Wireless interference, codec negotiation and multipoint switching can interrupt audio without indicating a failed driver. |
| No sound from either side | Confirm the selected output device and system volume, then test another application. | If other applications also fail, investigate the operating-system audio route before concluding the headset is defective. |
Important: A browser-based check reports only the events and device information exposed to the page. Confirm suspected faults with another application, cable, peripheral or operating-system diagnostic before replacing hardware.
Headphone Test Online FAQ
Can this test tell me how good my headphones sound?
No. It confirms channels and basic playback by ear. It does not measure frequency response or sound quality.
Why do I hear the tone from my speakers instead?
The browser uses the system's selected output, so switch the output to your headphones in the sound settings.
Is it safe to test at high volume?
Start with a low volume and raise it slowly. The tone is steady and can be tiring at high levels.
Does this test the headset microphone?
No. It covers playback only, so use the microphone test for the headset mic.
Why is only one side of my headphones working?
Check the balance and mono settings first, then the plug, the cable and the earbud mesh. Reversing the headphones on your head shows whether the fault follows the earcup.