PCHardwareTest guide

Speaker Test Online

Play left, right, stereo and center test tones or run a frequency sweep through whichever output your system is currently using. The tone slider covers 100 to 8000 Hz and the volume starts low, so you can separate a missing channel from a speaker that simply cannot reproduce a certain pitch.

Start Speaker Test Online

Speaker Test Online

Left, right, stereo and tone tests for speakers.

Not started
440 Hz
0.35×

Not playing.

This test generates an audio signal. Start low and increase the boost gradually. Digital boost cannot override your operating-system volume or a muted output, and high levels may cause distortion or discomfort. A browser cannot confirm that a physical speaker itself is undamaged.

Choosing a tone

The default 440 Hz is easy to hear and good for checking channels. Slide down toward 100 Hz to see whether small speakers produce any bass, and up toward 8000 Hz to check the high end. Raise the volume slowly: it starts at a conservative level on purpose, and sweeps can sound much louder at some pitches than others.

How to test left and right speakers

The left tone should come only from the left speaker and the right tone only from the right. Stereo plays both sides together, and center plays them equally, so it should seem to come from the point between your speakers. If center sounds lopsided, check the balance setting and the distance from each speaker to your seat.

Rattles, buzz and loose parts

Run the frequency sweep slowly and listen for a buzz that appears at one pitch only. That usually points to a loose grille, a cabinet resonance or a rattling cable rather than a dead driver. A constant hiss with no tone playing is more often amplifier noise or a ground loop.

Speaker test has silence, one-sided sound or crackling

  • No sound at all. Check the output device in system sound settings, the browser tab mute icon and the volume mixer before suspecting the speakers.
  • Only one side plays. Look at the left and right balance setting and the mono audio accessibility option, then check the cable or Bluetooth pairing.
  • Crackling or distortion. Lower the volume: if distortion disappears, the cause is clipping or a loose connector. Try a different cable or port.
  • Low tones are inaudible. Small laptop speakers cannot reproduce deep bass. That is a hardware limit, not damage.

A safe speaker channel and distortion check

Start at a low volume, keep the operating-system output device fixed, and use short test tones. Increase volume only enough to hear the channel clearly.

What you observeNext checkHow to interpret it
Only one channel is audibleCheck the left/right balance setting, cable seating and selected output device, then repeat with another known stereo source.If the same side is silent across sources and devices, the speaker or connection may need inspection.
Sound crackles at higher volumeLower volume and repeat with another source file or application.Distortion can originate in the recording, amplifier, speaker driver or software enhancement; do not keep increasing volume to reproduce it.
No sound is heardCheck mute, output selection, system volume and whether another application can play audio.A browser test cannot distinguish a disconnected speaker from a muted or misrouted output without checking the operating system.
Left and right seem reversedConfirm the device is not physically worn backwards and disable spatial-audio or channel-remapping effects temporarily.A reversed result can come from wiring, device orientation, virtual audio routing or software settings.

Important: A browser-based check reports only the events and device information exposed to the page. Confirm suspected faults with another application, cable, peripheral or operating-system diagnostic before replacing hardware.

Speaker Test Online FAQ

Can the speaker test damage my speakers?

Keep the volume low and raise it gradually, particularly with the sweep or with very low and very high pitches.

Why does the sound play from the wrong output?

The browser follows the system's default audio output. Change the output device in your operating system's sound settings.

What does the frequency sweep do?

It glides through a range of pitches so you can hear where a speaker buzzes, rattles or falls silent.

Why can I not hear very low tones?

Small laptop and desktop speakers cannot reproduce deep bass, and the limit is physical rather than a fault.

Related PC hardware tests

Continue with the Headphone Test Online, Microphone Test Online, Network Test Online, browse the PC hardware test guides, or run the whole suite from the PC Hardware Test Online homepage.